Starting Pecan Trees
Glen 'Cat' Taylor, Extension
Horticulturist, Commercial Pecans and Tree Fruits
There are three
major ways to establish a pecan tree: (1) plant pecan nuts directly in
place in the orchard and topwork the resulting seedlings to the desired
cultivar, (2) plant nursery seedlings in the orchard and topwork them to
the desired cultivar, or (3) plant a grafted tree from the nursery of the
desired cultivar. Each of these methods has its advantages and
disadvantages.
Starting With Nuts
Starting trees directly from nuts involves the least expense, but it
also requires two to four years for the tree to grow large enough to
topwork. Starting trees from directly planted nuts may be successful in
bottomland prone to flooding where transplanting nursery trees is
unsuccessful.
Nuts for planting should be mature, well filled, and free of insect
damage. Nuts from the Northern cultivars such as ‘Giles’ and ‘Peruque’ give
cold-hardy rootstocks and are preferred, especially in northern Oklahoma.
Seedlings of other cultivars give varying performance, but ‘Apache’ has
proven satisfactory for southern Oklahoma. Nuts may be planted directly in
the ground in the fall but these early planted nuts are prone to damage by
mice and squirrels. It is generally more satisfactory to stratify the nuts,
and then plant them in the spring.
Stratification is a cold, moist treatment that allows the pecan nut to
grow normally and vigorously in the spring. Stratification effectively
mimics the conditions that the nut would experience if buried in the ground
over the winter. The two prime requirements for stratification are that the
nuts stay moist (but not soggy), and cold (but not freezing).
For best results, after collecting the nuts in the fall, they should be
soaked in aerated water for two days prior to stratification. Nuts are
placed in a container and covered with tap water. An airstone connected to
a small aquarium air pump is placed in the bottom of the container. The
aeration is important, otherwise the nuts will soon use up the oxygen in
the water and die. This pre-soaking treatment is not absolutely essential,
but it helps ensure more uniform germination and growth in the spring.
After pre-soaking, the nuts should be packed in a moist material in a
container that has drainage holes. Alternate 2-inch layers of packing
material with a layer of nuts and top off with 2 inches of the packing
material. Moist sand or sawdust are traditional packing materials and work
well, but moist vermiculite, because it is sterile, can reduce the number
of nuts that rot during stratification. The container should be kept cold,
preferably between 36°F and 42°F for three months. Suitable sites for
storing the container are: (1) loosely wrapped in a plastic bag (not sealed
tightly) in the household refrigerator, (2) buried under soil or mulch on
the north side of a building, or (3) in an unheated building protected from
both warm temperatures and extreme cold. It is important that the nuts not
be allowed to dry out and that they be protected from warm temperatures,
otherwise the stratification process will be delayed or even reversed.
Nuts are planted outside in February or March, but not before their
three months stratification is completed. Nuts are planted 3 inches deep in
hills of three directly where the tree is wanted. The hills should be
marked with a stake so you can find the seedlings later. Thin to one tree
per hill after the first year. Control weeks and provide irrigation for
best growth. Seedlings will grow very slowly the first two or three years,
but will develop a taproot and extensive root system during this time.
Starting With Seedling Trees
The seedling trees can be bought from a nursery or can be grown from
stratified nuts planted in a nursery block (plant 3 inches deep and 10
inches apart within the row) or in small containers. The seedling trees are
planted in place and usually are allowed to grow in the orchard for at
least one year before being topworked. Buying seedling trees rather than
planting nuts in place saves two to three years of establishment time, and
seedling trees can be obtained relatively cheaply.
Topworking
Whether you plant seedling trees or nuts you will need to graft the
seedlings to a named cultivar, since pecan seedlings will not be true to
type. Currently the most popular type of graft with both experienced and
novice grafters is the four-flap graft, although the bark graft can also be
used (See OSU F-6230 ‘Four-flap Grafting of Pecans’, F-6204 ‘Bark Grafting
Pecans’ and F-6217 ‘Collecting and Storing Pecan Propagation Wood’). Place
the graft at least 3-4 feet off the ground. Leaving this much of the
seedling trunk improves the winter hardiness of the tree trunk. If cattle
are to be in the orchard, do all of the grafting 7-8 feet above the ground
to keep the graft out of reach. The tailgate of a pick-up backed up to the
tree provides a convenient working platform.
Starting With Grafted Trees
Using grafted trees is by far the quickest way to get a pecan orchard
into production, but it is also the most expensive. The source of the
seedling rootstock is usually unknown and the graft is usually near ground
level. This is more of a concern in northern Oklahoma than it is in
southern Oklahoma. Many successful orchards have been established using
grafted nursery trees.
Planting Pecan Trees
February, March or early April is the best time to plant the trees. If
buying grafted nursery stock, five to six foot trees are the best size.
Select the best adapted varieties for your location. See F-6201, ‘Pecan
Varieties for Oklahoma’. If the root system of the trees looks dry when the
trees arrive, soak the roots in water for three to four hours before
planting. The pecan tree is dormant at planting time, but it is extremely
important to prevent drying out of the roots during or after setting. Damp
burlap or other suitable cover should be used at planting time to prevent
damage to the tree roots from exposure to sun or wind.
(a) Dig hole large enough to accommodate the root system of the tree
without twisting the roots. Trim the taproot to a length of 20 inches. Trim
off all broken roots.
(b) The tree should be set 1 inch deeper than it was in the nursery. On
well-drained soils, plant the tree leaving a shallow basin around the tree
to make watering easier. On poorly drained soil plant the tree so it is on
a slight mound so water will not collect around the tree after a rain.
(c) Fill in around the tree roots with the moist topsoil, tamping with
the end of the shovel until the hole is 3/4 full.
(d) Water the tree to settle the soil.
(e) Finish filling the hole and water again.
(f) Remove about 1/2 of the top of the tree.
(g) Wrap the trunk with tree wrap, heavy brown paper, or aluminum foil
to prevent sunscald and borer injury. This will only be necessary for the
first two years.
It is important to avoid drought stress and
weed competition, especially during the first growing season.
Based on original material prepared by E.L.
Whitehead and Jim Gallot.
F-6207,
Starting Pecan Trees (pdf file)
This publication was originally published 12-99. This page
was created 02-00.
|
